Member Facebook

Wednesday, February 18, 2015

Wire-wrapped double bail for pendants

Carol Dekle-Foss
Last week, I was able to finish my pendants and I wanted to share how I wire-wrap them with a double bail. I like using double bails because they help prevent larger pendants from turning around when worn. For the life of me, I cannot remember where I learned this. Probably a found video somewhere, most likely YouTube.

This is a simple technique that takes just a little bit of practice. I hope you find it helpful in your jewelry creations!












The below video shows how I do this with a side-drilled pendant but this process also works with a front-drilled pendant as well. It's a bit blurry in a few places. Duh, the camera cannot focus when things are so close up.















What you will need:

Pendant: The ones pictured are 30x40mm and the small one is 20x30mm

Wire: I use about 28" of 22 gauge soft wire. It's a bit easier to wrap the pendants with than 20 gauge and to me, it doesn't look as bulky. Although the smaller tree of life necklace in the right hand corner is 24 gauge. Also, I give my wire a bath of liver of sulfur first, and then clean off with a Pro Polish pad before starting the wire wrap process.

Tools: Wire-cutters, chain nose and round nose pliers.


First, put wire through hole about 2 1/2" out the other side. Then fold both wires over the top of the pendant, crossing each other, and twist together. Bend both wires perpendicular to the pendant and wrap them around the round nose pliers to make the loop. Then wrap both wires around the bottom of the loop a few times. Snip off the smaller wire with wire cutters, and then using chain nose pliers, squeeze wire in the back of pendant to hide. Continue to wrap longer wire around pendant holding tight as you go so it it nice and snug to the pendant. Wrap as far down as you would like and then start wrapping back up the pendant. Continue until you reach the top of the pendant and then cut the wire, hiding the end in the back. I then use the round nose pliers to position where I want the bail and separate loops with the chain nose pliers. To finish, I touch up with a Pro Polish pad. Whew! I think the video will help to show the process better.

Once you get the hang of it, it's a fairly easy and fun to do, plus it will give your pendants a simple, rustic feel.

Try it for yourself and if you have any questions please feel free to contact me!

9 comments:

  1. Great article and loved the video! Will definitely try your method---and those pendants are really beautiful! :)

    ReplyDelete
  2. Thanks for the great video! You made it look so easy! :)
    The pendants are gorgeous too! Did you make those as well? What are they made of?
    Thanks!
    Florence

    ReplyDelete
  3. I love your cabochons I saw a picture of you tut in pinterest and I fell in love with this stones can I ask you were did you bought them or if you make yourself the carving?
    Mariela

    ReplyDelete
  4. thanks a lot cute works wow

    ReplyDelete
  5. Thank-you so much! I am a "newbie" and this really is great info! As a newbie I need to ask where does a person find Liver of Sulfer? I asked at a hardware store and they had no idea what I was talking about. I haven't noticed it in the craft stores.
    thanks again!

    ReplyDelete
  6. Thanks for your comment Lynne! I purchase mine from Thunderbird Supply. Here is the link. http://www.thunderbirdsupply.com/proddetail.aspx?stockNum=717007 Its really condensed and a lot goes a long way. Hope this helps!

    ReplyDelete
  7. I tried the product number above and it didn't work. Can you double check? I would love to find some like them. Thanks

    ReplyDelete
  8. Very informative, thanks. The stones are beautiful, please tell me there is a tutorial for those also!

    ReplyDelete